A few months ago I bought my 2nd B0-size (1030mm x 1456mm) tapestry. Usually you would need a large section of wall space to hang these up. Space that I didn't have in my room. So I opted for the other solution. Hanging them up on my ceiling.
Here are some instructions on how to get these up there:
1:I bought these simple hooks in a DIY store. These were originally fully closed inox hooks. I used some pliers open them up to a one quarter opening. Fixing them in the ceiling was easy with a small drill and some anchors to keep the hooks in place. Getting the markings up on the ceiling was a bit more tricky. I used a laser guide to project my guideline on the ceiling. This tool makes it a lot easier to measure where you'll need to fix your hooks. If you don't a tool like this, you'll make things a lot harder for yourself especially if you need to do this by yourself. I don't have any method on how to do it without a laser guide. You could consider buying one as they aren't that expensive and while you won't use it that often, it will still come in handy when you do need it. Make sure you get your markings correctly and take into consideration how much you want your tapestry to hang down in the middle.
2:Get some curtain sticks. I bought these extendable ones. The packages says they go up to 900mm in length, but you can extend them to about 1050mm.
3:Just hang them up using the opening in your hooks. The I've chosen these because of the small notch next to the ball finish at each end. The hooks fit nicely in these notches so the stick won't move around once up there.
4:Extended out this much, the stick bends down a little in the middle but this won't be visible anymore once the tapestry is up there as well.
5:Remove the plastic tubes from the tapestry and dismantle any unneeded parts. You won't need the cord anymore so you can dispose of it if you want. The tapestry I bought here had some plastic caps at the ends of each tube.
6:The plastic tubes here were too long. The max length I needed was 1040mm. I had to cut of 30 mm from these 1070mm tubes. As I didn't have any fancy equipment for this, I used the rudimentary tools at my disposal.
7:Refitted the tapestry with the shortened plastic tubes.
8:All that's left to do is sliding the inox curtain sicks inside the plastic tubes and hanging the thing up on the hooks in the ceiling. As you can see, the solid plastic tubes will remove any bending there was in the curtain stick.
That is all.
![](https://dl.dropboxusercontent.com/u/92797773/Loot/2015-05-loot01.JPG)
Here's the first one I bought.
![](https://dl.dropboxusercontent.com/u/92797773/Loot/2015-05-loot02.JPG)
![](https://dl.dropboxusercontent.com/u/92797773/Loot/2015-05-loot03.JPG)
![](https://dl.dropboxusercontent.com/u/92797773/Loot/2015-05-loot04.JPG)
I prepared my ceiling so I can have up to 4 B0-sized tapestries but you can even hang up smaller sized tapestries using a cord to make up for the difference in length.